7 Quick Tips for Solar Park Lights

In places where the environment needs to be preserved or parks there is a need for a natural lighting system when illumination is required at night. The use of solar park lights, in this case, eliminates trenching, power cabling, and any other works that may interfere with the soil structure. Solar park lights come designed for areas where the focus is on the aesthetics and the structure of the lights. Their environmental friendly working mechanism allows for use in such places and other recreational areas. At night, you can use Solar park lights to illuminate pathways, the lawn, and benches in a park. They aim to enhance the look of the park. This will ensure that the parks are useful at night by area residents. Here are seven quick tips you can use when designing your light. The aesthetic of solar park lights comes packaged in the design of the lighting and power source. The design is done in such a way that there is minimal hindrance to bird movement and exposure to dust or dirt. Aesthetics can also be achieved by the type of finishing, the perfect match between pole and structure coatings and the environment. Most of the solar park lights come with a decorative design depending on the style that appeals to your needs. Stylish lighting fixtures are available when you wish to add that aesthetic value on your park lights. The height of solar park lights is determined by the area that needs illumination. For instance, if you wish to light up the paths in the park then the height would be shorter than the one to be used to illuminate an entire park. As much as the brightness of the light depends on the height of the pole, you can still achieve the level of illumination you need with any height. This requires some professional calculation that starts with the area that needs to be visible and then choosing the light source while keeping in mind the height to brightness ratio. For the maximum efficiency and savings, solar park lights come with LED fixtures coupled with solar panels. The use of LED and high-pressure sodium lamps have been associated with cost savings in the sense that they produce bright lights without consuming too much power. Calculations are required to avoid light pollution or spill. After calculating the area where you want your solar park lights to illuminate, you will need the assistance of motion sensor technology to control the brightness of the lights depending on the limiting conditions you set. The poles used for solar park lights are usually made of hot-dipped, powder-coated, galvanized steel. The choice of material allows the streetlight to withstand a variety of harsh weather conditions. The use of steel poles in solar park lights allows for reflection of light rays because of its shiny surface. Besides boosting your lighting needs, steel poles are corrosion resistant. The type of pole you use should serve you for a longer time. The fixtures on solar park lights should provide a wide range of lighting intensity and distribution pattern that fits the area you need to illuminate. The height of the poles and the distance between them determines the overall illumination. There is a myriad of fixture styles available for park lighting. In areas that have high temperatures and strong sand winds, the masts are designed with vertical solar panels to limit silting and increase the performance of the solar park lights. Solar park lights should be easy to assemble and install. The components should be easily replaceable to reduce the cost and time of repair and maintenance. Besides, the solar park lights should allow for customization in case you need to change the bulb type, bulb intensity, bulb shade, or pole height. It has been observed that solar park lights with independent solar panels have a lower performance rate compared to all in one or rigid ones. If you are to go with solar lights that use split or separate solar panels, then you should determine the optimum tilt angle when installing installation. Tilting the solar panel makes it a self-cleaning product hence preventing silt and dust from settling on the surface. The rule of thumb when installing solar panels or PV arrays for your solar light is that they should be perpendicular to the sun's rays for maximum energy production. By default, the angle of tilt of your fixed solar panel should be equal to your latitude, plus or minus 15 degrees in winter, or summer respectively. Contemporary solar park lights come with adjustable solar panels that track the movement of the sun. The controllability of the solar panels allows for maximum conversion of solar energy into electricity. In short, adjusting the angle of tilt of your solar panel gives you a boost on energy production and reduces the need for cleaning. Experts in areas with extreme temperature conditions tend to avoid the use of lithium batteries in solar park lights. The reason being, Lithium batteries have poor performance when it comes to high temperatures. In most cases, the lead-acid battery has been an alternative to the lithium-ion battery. As much as performance is determined by the type of battery, it is also essential to consider the Depth of discharge (DoD) when selecting the battery for your solar lights. The DoD determines the lifespan of your battery. The best situation to use solar park lights is when the area of interest is far away from the grid power source. Also, they are suitable when no modification is required on the ground to facilitate the supply of electric power. The best solar park light is the one that is customized to your needs and a natural fit for all weather conditions. Generally, solar park lights should complement the open space.

1. Do out door solar lights work?

Solar Xmas Lights

2. Apart from candle light how else do villages generate light in India?

pl,do not think villages in india have no electricity.they have.at least most of them have. they do not burn candlesticks often as they are too expensive. they have gasolene lamps,kerosene lamps,spirit lamps and solar lights too.

3. outdoor solar lights - not working after being flooded?

I will politely disagree with the answer above. A bright white basking light is the best way to provide daytime heat for a bearded dragon. I have seen it for years, in many dragons, some over 8 years old. As for the specific bulb, most of the "specialized" reptile basking lights are halogen spotlights or floodlights. There is really very little difference in those and the halogen floodlights and spotlights you buy at the hardware store. There are some differences in the exact colour temperatures, but there are some differences in all bulbs, each "reptile" bulb from the other, etc. .. and they all work fine. You do still need a high output UVB bulb, and this can not be replaced with any other bulb. The halogen floodlights will not provide UVB, (neither will the halogen "reptile" basking lights, btw.) The only type of "all in one" basking lights that also provide UVB are called Mercury vapor bulbs. And they are usually pricey, and fragile, (they typically burn out easily). So, The halogens WILL NOT work for UVB needs

recommended articles
News
How Often Do You Think About Your Lights Or Your Air Conditioner, Unless Its Broken?
My guess is not very often.Leaving an unused device “on” when leaving a room does not strike one as much as leaving water taps open.And so we waste a lot of energy and money, while a bit of care and attention could change a lot.I was convinced that at WWF we also need to do more about our energy impact, and walk the talk, and wanted to ignite this change.I worked over 10 years on energy policy for WWF, but I wanted some practice. Thanks to an MSc in Wales at CAT and solar work experience at Hassler Energia I acquired more hands-on, practical knowledge needed for this new challenge.Now I am looking for ways to make our offices more energy efficient, and to switch our energy supply to solar.Fifteen WWF offices across the world are already running on solar energy and I’ve seen the energy consumption drop drastically in all offices where we trained staff and made some technical changes, like replacing inefficient air conditioners. It works!But I couldn’t have done this without my colleagues.While they are concerned with other environmental issues in their day to day work, they are still enthusiastic to learn more about their impact and reduce their energy consumption.Switch off the plug — switch on the sun: Energy policy into practiceThis week it is WWF EPO’s turn!We have launched a Sustainable Energy Week, a chance for everyone to learn and share how to make energy changes that matter and to become more familiar with the solar installation on our roof and smappee.This cute device enables everybody to easily check at any time how much electricity we use and solar electricity we produce.Everyone in the office can do it, techie or not.When do you start? You might be surprised what a difference it makes.Jean-Philippe Denruyter is the manager for Applied Energy Solutions at WWF. He is based in Belgium. jdenruyter@wwf.euLearn more about WWF’s work on solar energy.·RELATED QUESTIONWhy don't hotel rooms have ceiling lights?My hotel building is over 100 years old, so we have ceiling lights. We also need a ladder to change a bulb 11' from the floor. It can take 20 minutes for 1 bulb! This is one reason that we have changed to the longer lasting (and more economical) low-energy bulbs.I would be delighted to have wall lights instead. Retro-fitting them would however be even less economically sound.Higher than average ceilings mean ladders to change the bulbs in ceiling fittings, and this extends the maintenance time and convenience for staff enormously. Even normal height ceilings mean that a chair is needed to swap a bulb out. Wall fittings are so much more convenient for both staff and customers, reducing the time taken to get light again!As Michael Forrest Jones says - anything other than a simple bulb swap requires the power to be cut to the whole circuit (which may be more than just a few rooms). This makes it very awkward to do emergency repairs after dark! -- Been there done that... Go with wall fittings that can be isolated in-room!In short:I have ceiling lights.I don't like them, as they are awkward for maintenance.Replacing them would be expensive and extremely difficult - basically a total rewire of the hotel lighting system.Design engineers are not stupid. they note the first 2 points!
Garden Lighting Is a Necessity
How to Plan Your Vegetable Garden Lighting
Can I Use My Solar Lights As Battery Chargers?
Solar Lights Aren't Working When My Electrical Lights Are On!!!?
Solar Lights for Outdoor Lighting
I Had Outdoor Solar Lights Stored in My Garage 2 Years. 3 Days Ago I Put Them in My Yard, They're No
You Can Curtail Your Energy Bill by Installing More and More LED Solar Lights
How to Light Up Your Exterior Space
Hanging Baskets in the Garden Where to Hang Plants Outdoors
related searches
How Often Do You Think About Your Lights Or Your Air Conditioner, Unless Its Broken?
Garden Lighting Is a Necessity
How to Plan Your Vegetable Garden Lighting
Can I Use My Solar Lights As Battery Chargers?
I Had Outdoor Solar Lights Stored in My Garage 2 Years. 3 Days Ago I Put Them in My Yard, They're No
You Can Curtail Your Energy Bill by Installing More and More LED Solar Lights
How to Light Up Your Exterior Space
Hanging Baskets in the Garden Where to Hang Plants Outdoors
Efficient Solar Garden Lights for Homeowners

Contact Us

Copyright2021@KemecoLighting

Service Support

kemeco@kmc-ltd.com

 Copyright © 2021 Kemeco |Sitemap